A laptop screw can be a tricky thing to remove. Because they are not exposed, you need to know how to manipulate them in order to get them out. You should use fine needle nose pliers to grip them. You should place your pliers in the slot where the screwdriver normally goes, and use a light grip to avoid damaging the screw. As a rule, laptop screws cannot withstand the same pressure as wood or metal screws, so you should use finesse to remove them.

One way to loosen a laptop screw is by using penetrating oil. This method will work if the screw is made of steel, but won't work if it's made of another material. You can also use WD-40 to loosen a screw. Just make sure that the WD-40 gets into the motherboard and the screw support. In most cases, this should be sufficient.

You can also buy laptop screws that come in kits. The screws are shaped like wafers, and many OEMs use them. However, they're a little harder to center. They're also easier to damage your laptop if you try to overtighten them. In that case, it's a good idea to use a power driver to remove them.

Regardless of which type of screwdriver you use, you need to be sure to use the right size for the job. The screws are delicate, and using the wrong screwdriver can strip them. To avoid stripping, use a screwdriver with a larger head, or a flat-bladed screwdriver. Regardless, it's essential to use caution when using a screwdriver on a laptop.

Screws for laptops have various sizes that depend on the type of component. For example, 3.5-inch hard disk drives and motherboards typically use screws with a #6-32 UNC thread. However, other components may use different sizes of screws, such as DVI connectors. Some cases use plastic standoffs that are not quite as secure.

Another option is to drill out the laptop screw, but this should be done with caution. This method is dangerous, since it will permanently damage the threads. Because laptop screws are small, you should use a drill bit that is a little smaller than the screw's diameter. Also, be sure to use a metal drill bit that has a shallow impression on the screw head.

A stripped screw can't be extracted with a standard screwdriver, so you will need a screw extractor to pull it out. You can buy one in your local hardware store or online. A screw extractor can extract any kind of screw, including wood screws and lag screws. It can also remove screws attached to the motherboard.